Now in stock
This kit will fix any Fiero bent clutch pedal problems.
Once installed your clutch pedal will be stronger than a new pedal!
History: Many years ago Ed Parks told me that the clutch pedal on a Fiero never gets bent out of shape. He said even the 1984 aluminum pedals. The part of the clutch pedal that gets bent is the steel U bracket that is riveted to the clutch pedal.
If your clutch pedal is bent in the U area you can remove it from your Fiero and using a vice and large pipe wrench or a large adjustable wrench etc you can bend it back into the correct shape. It is really quite easy to bend. I can see why they bend out of shape. The one problem with bending it back into the correct shape is it weakens the steel some and everytime you do it it weakens the steel even more.
This kit will make any Fiero clutch pedal stronger than new. You will, using a workbench vice and an adjudstable, pipe wrench etc, bend the U piece of the clutch pedal back into the original shape. It is not hard to do. Once you have bent the U bracket back to it's original shape you weld in my repair pieces.
Once the U piece is bent back into the correct shape you will weld in the rebuild kit. TIG is best but it can be done with a wire welder. Once this kit is installed your clutch pedal will be very, very HD and should never get bent out of shape ever again.
NOTE: Works in the aluminum clutch pedals but will not be as strong as when this kit is installed it in a steel clutch pedal. When installed in a steel clutch pedal you can weld the U bracket to the steel pedal arm.
This is the common way a typical Fiero clutch pedal gets bent out of shape:
Clamp it in a workbench vice:
I used a pipe wrench. Bend it back to the original shape as shown below. It is not hard to bend.
| Grab it like this.
|| Make it parallel to the arm below.
|| Grab it like this.
|| Make it square like this.
Your pedal should now be like it was when it was new. Some slight miss shape is OK. Close is good enough.
Set the new steel piece on the peddle as shown below and tack weld it in place:
Weld it as shown below:
To make it easier to weld it to the arm to the U bracket use the round pin included in the kit:
As long as I had my welder going I decided to weld the arms together some. Probably not necessary but I felt it would make the clutch pedal even more HD.
A note of caution: I also welded around the tube. I found you should not weld around the tube. When the tube cools it shrinks some and the plastic bushings will not fit back in the tube. Do not weld any higher than what is shown in the picture above.
These pictures show the new steel piece will not hit any of the brackets etc:
If you have an early style clutch pedal with the two step pin this might be a good time to upgrade to the later style small pin:
I do not offer free shipping.
Because I use postal flat rate boxes for heavy orders there is no program that can add the proper amount of shipping to every order. So all shipping is added manually by myself after you place your order. That is explained here: Shipping added later explanation
When you place an order the shipping amount will show $0.00. Soon after you place an order you will receive an email confirmation that shows the amount of shipping that was added to your order.
Shipping depends on quantity ordered and distance from Milwaukee, WI. (Midwest-USA)
Final shipping cost is determined by weight of the item(s) and distance from Milwaukee, WI. Shipping prices generally quoted are for items shipped to the Midwest area in the USA. If you are ordering a single item or multiple items the total shipping price is determined after you place the order. I try to keep my shipping prices to a minimum and use Postal Flat Rate boxes whenever I can utilize them for an order.