This is my new aluminum slave cylinder for the Muncie 2.8 V-6 4 speed equipped Fieros.
- Cast aluminum housing will not corrode like steel and cast iron.
- Comes complete with a new push rod.
- Top quality!
Since the demise of the original GM steel slave cylinders the replacement cast iron aftermarket slaves have proven to be very low quality. My aluminum slave is top quality. It features a double seal on the piston. Includes a new push rod and bleeder valve.
The bore size of the cylinder is 13/16" (0.8125") or 20.64 mm
Aluminum housing slave cylinder for the 85-86 V-6 4 speed:
Features a dual seal piston:
- Less $$ than the poor quality cast iron replacements available today!!!
- Complete with a new push rod and bleeder!
- Solves most clutch release problems!
Also check out my new one man slave cylinder bleeder tool.
An excellent trick to bleed the clutch system:
When I changed from an automatic to a Getrag 5 speed I used the trick Bob Hughes suggested many years ago: Take a clean glass jar (like a mayonnaise jar) with a lid. 1 quart or smaller is OK. Poke 2 holes in the top of the lid. Get some clear tubing from a hardware store. Vinyl clear tubing is cheap. Get 12 feet or so. The ID of this tube should be such that it goes over the bleeder of the slave end snug. Make the holes in the lid of the jar just big enough to allow the tubing to go thru but be a tight fit. Attached one tube maybe 2 feet long to the slave bleeder. Attach the other long tube end to a vacuum port on an engine (I used my truck). Coat the threads of the bleeder screw with some heavy grease or wrap it with Teflon tape so no air gets drawn in past the threads of the bleeder screw. Start the engine you are using for vacuum and let it idle. Make sure you have someone at the front to fill the reservoir and open the bleeder. The vacuum of the running engine will draw the fluid thru the system. Worked excellent for me when I did it.
Fiero V-6 4 speed aluminum slave cylinder $59.99
I do not offer free shipping.
Because I use postal flat rate boxes for heavy orders there is no program that can add the proper amount of shipping to every order. So all shipping is added manually by myself after you place your order. That is explained here: Shipping added later explanation
When you place an order the shipping amount will show $0.00. Soon after you place an order you will receive an email confirmation that shows the amount of shipping that was added to your order.
Shipping: Shipping is $7.50 (Midwest-USA)
Final shipping cost is determined by weight of the item(s) and distance from Milwaukee, WI. Shipping prices quoted are for items shipped to the Midwest area in the USA. If you are ordering a single item or multiple items the total shipping price is determined after you place the order. I try to keep my shipping prices to a minimum and use Postal Flat Rate boxes whenever I can utilize them for an order.