Rodney Dickman's Automotive Accessories Checkout   
  Top » Catalog » •Electrical » My Account  |  Cart Contents  |  Checkout   
•Delorean Parts, etc
•Pontiac Mera
•Replacement Sander Pads
•Corvette Headlight Gears
•Corvette & GM Tach Filters
•Firebird Headlight Gears
•GM Headlight Rebuild (Other)
•Ford Window Rebuilding
•Getrag 238 bearing retainer
•Chrysler Light Motor Repair
•Chrysler Electric Window Repair
•Buick Reatta
•Kubota Lawn Mowers
•Dyson Hand Held Vacs
•Star (Torx) Exhaust Studs
•Isuzu Trooper 3.4 Swap
•Kit Car Parts & Acc's
•Zero Lash Sway Bar Links
•Fiero Apparel
•Fiero Stickers
•Fiero Audio
•Fiero Headlight Gears
•Light Bulbs
•Cooling System
•Fiero Engine
•Fiero Cables
•Fiero Exhaust
•Fiero 3.4 Engine Swap
•Fiero Interior
•Fiero Exterior
•Fiero Shifters
•Shifter Boots, Rebuild Kits etc
•Steering & Suspension->
•Fiero Tools
•Fiero Manuals
•Clutch Masters & Slave Cylinder
•Fiero Transaxles
•Research & Development
•Seconds, Sale Items, etc..
•Used Fiero parts
What's New? more
1997-2004 C5 Corvette Headlight Adjusters
1997-2004 C5 Corvette Headlight Adjusters
Shipping & Returns
Privacy Notice
Conditions of Use
Contact Us
1985-1988 Delay wiper board rebuild kit $8.00




Repairs many common Fiero wiper problems. Erratic or non existent delay action, phantom wipes, 3 wipes per wash cycle irregularities.


Phantom wipes are caused by wear in the switch assembly in the steering column. If the wear is too great this kit may not stop all the phantom wipes. The only cure will be to replace the wiper switch which not an easy job. Considering the cost and effort required to replace the wiper switch in the column it is best to first replace the capacitors on the delay board to see if that eliminates the phantom wipe problem. In most cases it will certainly eliminate a large percentage of the phantom wipes.

There are generally only 2 delay wiper boards used on the 1985-1988 Pontiac Fiero. Board number: 22048550 and board number: 22062692/22062693. If you have a delay wiper board that is not one of these listed it may not have the required parts included. Please email me for more info if you find a board with a different number other than the two listed above. This kit contains enough parts to rebuild one or the other. Some parts will not be used. Includes a length of .032" 60/40 solder which is preferred for circuit board repairs. A pencil soldering iron is required. A soldering gun is too hot and large for this type of soldering. 

Wiper Kit writes:

There are two major problems that affect Fiero wiper / washer systems. One is the dried-up capacitors on the pulse board and your rebuild kit deals with that very effectively.

The other problem is that there was a run of bad windshield wiper switches. They were installed in 85 and 86 Fieros with tilt wheels and delay wipers; these switches are very failure prone - symptoms are phantom wipes, wipers turning themselves on, can't turn the wipers off, etc.

The cure for these bad wiper switches is to replace them with the wiper switch for '87 or '88 Fieros. That switch is mechanically and electrically compatible - it's a drop-in replacement. They're also less expensive than the early version switch (go figure). This will solve the problem and prevent it from returning. This is the switch this is in the steering column under the steering wheel, not the cruise/turn signal stalk.

 How to remove and replace a capacitor:

Heat one leg and lift the old capacitor up. Heat the other leg and tilt/lift the capacitor up slightly. Do it to the other leg of the capacitor. Repeat. Do this until it comes away from and off the circuit board.

The holes are now full of solder. How do you get the solder out of the holes? Heat one hole up and quickly blow air on it. Using you mouth works fine.





Shipping:   Shipping in the USA via First Class Mail is $5.50

Shipping to areas outside of the USA: Generally I ship postal air first class mail. Shipping varies depending on what country they are going to. It ranges from $11.50 to Canada to $18 or more to Australia etc.




I do not offer free shipping.

Because I use postal flat rate boxes for heavy orders there is no program that can add the proper amount of shipping to every order. So all shipping is added manually by myself after you place your order. That is explained here: Shipping added later explanation 

When you place an order the shipping amount will show $0.00. Soon after you place an order you will receive an email confirmation that shows the amount of shipping that was added to your order.


This product was updated on Tuesday 12 February, 2019.
Customers who bought this product also purchased
Lift Arm Rebuild Kit
Lift Arm Rebuild Kit
Isolation relay Pontiac Fiero 1984-1986
Isolation relay Pontiac Fiero 1984-1986
85-88 Fastback Exhaust Tip Shield Plates
85-88 Fastback Exhaust Tip Shield Plates
OEM-Style Manual Shift Boot Ring
OEM-Style Manual Shift Boot Ring
Door Hinge Pin
Door Hinge Pin
"NEW"  Hinge Mounted Rear Decklid Strut Kit
"NEW" Hinge Mounted Rear Decklid Strut Kit
Shopping Cart more
0 items
Notifications more
NotificationsNotify me of updates to 1985-1988 Delay wiper board rebuild kit
Tell A Friend
Tell someone you know about this product.
Parts Finder
Use keywords to find the product you are looking for.
Advanced Search
Reviews more
Write ReviewWrite a review on this product!

Copyright © 2020 Rodney Dickman's Automotive Accessories
Designed and Maintained by SoftNuTek